A non-loadbearing internal timber partition with one window opening: trimming studs, head and sill trimmers, studs above and below, insulation between the studs and plasterboard lining on both sides. Opening width, height, position and sill height, Stud section and maximum spacing, Plate thickness, Noggings, Lining thickness and layers on each side, Insulation and finishes
Category: Framed Walls › Timber Frame Walls
By Huu Khanh Nguyen · Updated November 14, 2026
| Name | Default | Unit |
|---|---|---|
| Length | 4000 | mm |
| Height | 2400 | mm |
| Opening width | 1200 | mm |
| Opening height | 1200 | mm |
| Opening position | 1000 | mm |
| Sill height | 900 | mm |
| Stud width | 70 | mm |
| Stud thickness | 45 | mm |
| Maximum stud spacing | 600 | mm |
| Plate thickness | 45 | mm |
| Noggings | false | |
| Maximum nogging spacing | 1350 | mm |
| Nogging section | 45 | mm |
| Lining thickness | 10 | mm |
| Lining layers side one | 1 | |
| Lining layers side two | 1 | |
| Timber finish | timberSpruceSawn | |
| Lining finish | ceilingPlasterboard | |
| Frame offset | layersSideOne * liningThickness | mm |
| Stud top | sizeZ - plateThickness | mm |
| Head trimmer underside | sillHeight + openingHeight | mm |
| Head and sill trimmer thickness | openingWidth <= 2000 ? 35 : (openingWidth <= 2400 ? 45 : (openingWidth <= 3000 ? 90 : 135)) | mm |
| Trimming stud thickness | [[45, 45, 90, 115], [45, 70, 90, 135], [70, 90, 140, 180], [105, 135, 210, 270]][(openingWidth > 1800 ? 1 : 0) + (openingWidth > 3000 ? 1 : 0) + (openingWidth > 3600 ? 1 : 0)][[35, 45, 70, 90].indexOf(studThickness)] | mm |
| Left run end | openingX - trimmingWidth | mm |
| Bays left | Math.ceil(runLeft / studSpacing) | |
| Pitch left | runLeft / bayCountLeft | mm |
| Right run length | sizeX - openingX - openingWidth - trimmingWidth | mm |
| Bays right | Math.ceil(runRight / studSpacing) | |
| Pitch right | runRight / bayCountRight | mm |
| Bays across the opening | Math.ceil(openingWidth / studSpacing) | |
| Pitch across the opening | openingWidth / spanBays | mm |
| Nogging rows | nogged ? Math.ceil((sizeZ - 2 * plateThickness) / noggingSpacing) - 1 : 0 | |
| Insulation | true |