Retractable Louvred Pergola

Retractable Louvred Pergola

A roof of aluminium louvre blades that tilt open and then slide together into a stack at one end, leaving the roof area open, carried on posts or set onto an existing structure. Blade section, Post size and number of posts, Three or four sided frame

Details

Category: Outdoor Shelter › Pergolas

By Huu Khanh Nguyen · Updated November 13, 2026

Parameters

NameDefaultUnit
Width3900mm
Depth4526mm
Heightposts == 0 ? beamDepth + rise + flashingHeight : 3000mm
Posts4
Post size100mm
Blade section220/35
Blade lengthroofX - framePad - 2 * frameGap - 2 * sideFrameWidthmm
Blade countMath.floor((rearEdge - frontEdge - frameAllowance) / bladeCentres + 1e-9)
Blade angle0°
Retraction0
Blade centres205mm
Beam depth300mm
Frame gap15mm
Plate sizepostSize == 100 ? 200 : 250mm
Plate thickness12mm
Beam width50mm
Gutter width245mm
Frame allowanceposts == 4 ? plateSize + beamWidth : posts == 2 ? plateSize / 2 + beamWidth + 25 : 2 * beamWidthmm
Left beam positionposts == 4 ? plateSize / 2 - beamWidth / 2 : 0mm
Frame finishpowderRal9011
Blade finishpowderRal9011
Side frame width115mm
Drive frame height165mm
Passive frame height117mm
FramethreeSided
Blade stackoneEnd
Roof pitch0°
Post sectionsquare
End frame gap25mm
Beam end gap9mm
Beam startposts > 0 ? (plateSize - postSize) / 2 : 0mm
Rear edge of the blade framesizeY - beamStart - beamWidth - endGapmm
Front edge of the blade frameringed ? beamStart + beamWidth + endGap : beamStart + frontGapmm
Frame length allowancedouble ? 584 : ringed ? 361 : 242mm
Frame with end framesframe != 'threeSided'
Double retractframe == 'doubleRetract'
Blades stacking to the front enddouble || (ringed && stack == 'bothEnds') ? Math.ceil(bladeCount / 2) : 0
Blades of the rear framedouble ? bladeCount - stackFront : bladeCount
Post width along xpostShape == 'narrow' ? 100 : postSizemm
Plan distance between the side beam centressizeX - (posts > 0 ? plateSize / 2 : beamWidth / 2) - leftBeamX - beamWidth / 2mm
Height difference between the two side beamsbeamSpan * Math.tan(pitch * Math.PI / 180)mm
Width of the roof along its slopesizeX + beamSpan * (1 / Math.cos(pitch * Math.PI / 180) - 1)mm
Flashing heightpitch > 0 ? 94 * Math.cos(pitch * Math.PI / 180) + (leftBeamX + beamWidth / 2 - ((leftBeamX + beamWidth + frameGap) - Math.min(79, (leftBeamX + beamWidth + frameGap)))) * Math.sin(pitch * Math.PI / 180) : 0mm
Pivot pin projection20mm